HP Officejet Pro L7680 - Set up the device for wireless communication using software

background image

Set up the device for wireless communication (optional)

20

Network authentication: The device’s factory default

setting is Open, which does not require security for

authorization or encryption. The other possible values

are OpenThenShared, Shared, and WPA-PSK

(Wi-Fi

®

Protected Access Pre-Shared Key).

• WPA increases the level of over-the-air data

protection and access control on existing and future

Wi-Fi networks. It addresses all known weaknesses

of WEP, the original native security mechanism in the

802.11 standard.

• WPA2 is the second generation of WPA security;

providing enterprise and consumer Wi-Fi users with

a high level of assurance that only authorized users

can access their wireless networks.

Data encryption:

• Wired Equivalent Privacy (WEP) provides security by

encrypting data sent over radio waves from one

wireless device to another wireless device. Devices

on a WEP-enabled network use WEP keys to encode

data. If your network uses WEP, you must know the

WEP key(s) it uses.

• WPA uses the Temporal Key Integrity Protocol (TKIP)

for encryption and employs 802.1X authentication

with one of the standard Extensible Authentication

Protocol (EAP) types available today.

• WPA2 provides a new, encryption scheme,

the Advanced Encryption Standard (AES). AES is

defined in counter cipher-block chaining mode

(CCM) and supports the Independent Basic Service

Set (IBSS) to enable security between client

workstations operating in ad hoc mode.

NOTES

• Make sure the device is not connected to the network

using a network cable.

• The sending device must have built-in 802.11

capabilities or an 802.11 wireless card installed.

• HP recommends that the device and the computers

that use the device be on the same subnet.

Set up the device for

wireless communication

using the control panel

NOTE: To use this method, you must have a wireless

network set up and running.

1. On the control panel, press the Setup button.
2. Press an arrow button to move to Network, and then

press OK.

3. Press an arrow button to move to Wireless Setup

Wizard, and then press OK.

4. Follow the display instructions to complete the setup.
If you encounter problems, see “Solving wireless

problems (some models only)” on page 23.

Set up the device for

wireless communication

using software

For Windows

1. Remove the protective cover from the device’s

network connector.

2. Temporarily connect the device to an available port

on the network hub, switch, or router with a network

cable (sold separately).

3. Close any applications that are running on your

computer system.

background image

Set up the device for wireless communication using software

21

Engl

ish

4. Insert the Starter CD into the CD drive. You must run

the installation program at least once from the
Starter CD and create a wireless connection.

If the CD menu does not start automatically,
double-click the setup icon on the Starter CD.

5. On the CD menu, click Install and follow the

onscreen instructions.

6. On the Connection Type screen, select Wireless,

and then click

Next.

7. Follow the onscreen instructions to complete the

installation, and when prompted, disconnect the
cable.

If you encounter problems, see “Solving wireless
problems (some models only)” on page 23.

For Mac OS

1. Open the AirPort Setup Assistant, and then follow

the onscreen instructions for joining an existing
wireless network (hpsetup).

2. Double-click the setup icon on the Starter CD,

and then follow the onscreen instructions.

3. When prompted, click Printer Setup Utility to add

the device.

If you encounter problems, see “Solving wireless
problems (some models only)” on page 23.